To start, place a small dot of glue on a surface (cardboard, paper sheet, etc.). This helps to dose the glue properly and avoid excess that could smudge the bases and stones.

With a fine tip (like a toothpick), take a small amount of glue and place it in the center of a cabochon base. Place the cabochon in its base, then apply slight pressure. Adjust it so it is well positioned.

Repeat this step for all bases and cabochons.

Wait for complete drying or at least 5 to 10 minutes.

Now open a 3mm jump ring using 2 flat pliers, then attach the 6mm cabochon connector at the bottom of the earring base.

Connect the cabochon connector at the bottom of the 6mm connector, then finish with the oval cabochon pendant.

Make sure to properly close the jump rings. If needed, place the assembly in front of a window to check if the rings are correctly closed.

Repeat all the steps to make the second earring.

Your jewelry is finished!

Beautiful creation!