Pendant assembly:

To start, cut a brass thread about 30cm long.

Choose your natural stone beads and string them on the thread, playing with shapes, sizes, and shades.

Position the stringing at the edge of the pendant to determine the placement of the beads.

After determining At the location, wrap one side of the thread for 2 turns leaving about 2mm above the last bead. This free space is essential because to weave the thread between each bead you need room to avoid creating too much tension between the beads.

Now place the stringing at the edge of the pendant and wrap the thread for 2 turns on the other side, leaving about 2mm above the last bead.

Now start weaving the thread in a spiral between each bead. This will tighten the beads against the edge of the pendant.

When all the beads are perfectly fixed, wrap the thread at the edge of the last bead to stop the thread. Cut the excess thread flush and flatten it with flat pliers.

Bead assembly on the earring support:

Cut a thread about 10cm long. Wrap the thread around the support ring for 2 turns.

String 3 beads onto the thread.

Position the beads along the edge of the support without tightening the beads too much.

Then wrap the thread above the last bead for 2 turns, then spiral down between each bead.

Secure the thread by making 1 turn then cut the excess. 

To finish, gently open the earring support ring and insert the pendant.

Be careful not to open the support ring too much or you risk breaking it. Proceed little by little, opening just enough to insert the pendant.

Proceed in the same way but symmetrically in the order of the beads to make the second loop.

Your jewelry is finished!

Beautiful creation!