To start, assemble 3 set connectors and one set pendant with 3mm rings.

This gives you a fluid and light setting chain.

Connect the small chain to the central ring of the chandelier with a 3mm ring.

Cut 4 pieces of rosary chains (2 per earring), keeping 8 natural beads per chain, about 5.5cm.

Cut 4 pieces of gold chains (2 per earring). For measurement, cut at 7.2cm.

Cut cleanly just below where the chain has flattened links. Measure up 7.2cm, which leaves 3 areas of flattened links. Cut at the 5th link just above the last flattened link. This step must be precise because the neat finish of your jewelry and its perfect symmetry will depend on the exact length of the chains.

To ensure the rings pass through the fine gold chains without forcing, use a reamer or a pin to widen the last links.

Now, connect the chains to the chandelier. Use 3mm rings for the rosary chains and 3x2.4mm oval rings for the fine gold chains.

To finish, attach the earring base to the top of the chandelier with 3mm rings.

Repeat the assembly steps for the 2nd earring.

And there you go! Your creation is complete!