Circle pendants
 Horn moon pendants
 A 6mm set connector
 Textured connectors
 Natural beads
 3mm and 4mm rings
 Rosary chain and/or confetti chain
 Flexible 0.4mm brass wire
 Clasps

For the necklace with a crystal quartz stone floating inside the circle:

Cut a brass wire about 30cm long, then wrap one end of the wire around the edge of the closed ring 3 times. Cut the excess wire and tuck in the end for a neat finish. Then insert a small bead before making 3 wraps around the edge of the ring. Your bead should be placed on the outside of the circle.

Tighten the thread towards the center of the circle, then string a crystal quartz bead and position it at the center of the circle.

Wrap the thread 3 times around the bead to secure it before going back across for 3 wraps around the edge of the ring.

String a small bead again before making 3 wraps around the edge of the ring.

Then place small beads where desired on the outer part of the ring with thread.

For a more dynamic look, position the small beads randomly. A deliberately messy look! Do not place them symmetrically or too regularly.

To finish, attach the crescent horn with a 4mm ring and on the top of the circle the textured connector with a 4mm ring.

Cut your chain to the right length, then place the clasp and the extension chain at the ends.

Attach your pendant suspension to the chain with a 4mm ring.

For the rosary chain necklace:

Assemble the different elements with 4mm rings. The crescent horn at the bottom, the setting, the circle pendant, then the textured connector.

Cut 20cm of rosary chain and 2 pieces of simple link chains to the desired length. Attach the 2 chains to the rosary with 3mm rings (or 3mm oval rings).

To finish, place the clasp and the extension chain at the ends of the chains, then attach the pendant suspension to the chain with a 4mm ring.

And there you go! Beautiful creation!