Mother-of-pearl beads
 Ball head studs
 6mm pendants
 Mounted beads
 A twisted circle pendant
 6mm rings
 3mm rings
 Diamond chain
 Extension chain
 A ball clasp

To start, mount 5 mother-of-pearl beads on head pins with ball ends.

Be careful to make loops large enough to pass around the twisted pendant.

The beads must be mobile and fluid!

Then open the loops created in a spiral and attach them to the pendant. For a beautiful result, place them in size order, the largest/widest in the center and the smallest on the outside.

Then open a 6mm ring and insert a mounted bead, a small 6mm pendant, and a mounted bead. Attach the ring to the pendant.

Continue like this to place 6 compositions of mounted beads/pendants. Place them alternating between the mother-of-pearl beads.

Finally, cut a piece of diamond chain to the desired length, here we took 45cm so that the pendant falls just above the sternum. Adjust the size to your liking.

Then cut a small piece of about 5cm of extension chain, this will allow you to adjust the necklace to your necklines.

Attach the clasp and the extension chain to the ends of the chain with 3mm rings.

And Voilà! Beautiful creation!

You can complete your creation with matching hoop earrings!