A pair of square stud earrings
 Medium crumpled pendants
Ball link chain
6x8mm cabochons
3mm jump rings
Flat pliers
A reamer

To start, cut 4 pieces of chain 2.2cm long and widen the links at the ends with a reamer. This will make it easier to pass the jump rings later.

Then open a 3mm jump ring and insert the pendant and a chain, close the ring properly. Do the same on the other side of the pendant.

Now, open a new 3mm jump ring and thread one of the chains, connect the ring to the earring base making sure not to twist the chain.

Open a 3mm jump ring and thread the other chain, still without twisting it, connect the ring into the hole of the earring base. Both rings can pass through the same hole, which means no extra ring is needed.

To finish, glue the cabochons onto the earring bases, making sure to center them well.

Wait for complete drying before handling them.

And there you go! Beautiful creation!