Bohemian beads 6mm, 8mm, and 10mm
 0.5mm linhasita thread
 8mm closed rings
 a screw clasp

To start, cut a linhasita thread about 60cm long.

To attach the thread to the clasp, make a series of 3 knots with the end of the thread on an 8mm closed ring. Then cut the excess and burn the small end of the thread to secure the knot.

Thread the beads starting with the 6mm beads, then the 8mm, and the 10mm in the center. Then continue symmetrically to finish threading.

Thread the 8mm ring then make a series of 3 knots right at the edge of the ring.

Be careful to maintain fluidity between the beads; to do this, before tying the knots, curve the necklace. A necklace that is too stiff will not be comfortable to wear!

To finish, place the screw clasp to connect the closed rings.

And there you go! Beautiful creation!