Tie the nylon thread on the ring of the Zircon set connector. Make several knots to be sure the thread will not come undone. Cut the excess thread about 3mm from the knots.

Now string 4 11/0 seed beads (green), one flower bead, one 11/0 seed bead (purple) and one 15/0 seed bead (salmon).

Pass the thread through all the beads except the 15/0 seed bead (salmon). This one will serve to block the threading. 

Pass the thread through the ring of the connector then pass back through the first green bead.

Now, string 3 11/0 seed beads (green), one flower bead, a 11/0 seed bead (purple) and a 15/0 seed bead (salmon).

Pass back through all the beads except the small salmon bead as before.

You have just assembled a first pair of flowers.

Now pass back through the ring of the set connector. 

Repeat the previous steps to assemble the other flower stems. In total, you must assemble 8 flowers to get a pretty flower cluster.

To finalize and secure the assembly, make several knots on the ring of the connector, being careful not to trap the thread in the flower petals or the beads!

Between each assembly, be sure to pass back through the ring of the set connector. This way your cluster will form a pretty ball.

To finish, gently open the ring of the sleeper earring then insert the ring at the top of the set connector.

Repeat all the steps for the second earring.

Your jewelry is finished!

Beautiful creation!

Find all the supplies for making this jewelry at the bottom of the page.