58 oval beads in 24K metal
 Hoop earrings
 Ball stud earrings
 Fine 24K chain
 4mm cabochons and connector supports
 Glue
 Square pendants and small navettes and diamonds
 Oval rings

To start, cut all the chains following the cutting plan below. (see at the bottom of the tutorial)

Tip: To help you cut the chains symmetrically, lay the chain flat in front of a ruler. Then locate the link to remove at the measurement mark. Next, grab this link with the cutting pliers, lift the chain, the chains will naturally fall down, giving you the cutting mark for the 2nd chain piece. Cut at the right spot.

Thread 7 beads on the hoop, then the 2 chain pieces (the one hanging outside and the one that will form the curve under the hoop).

To guide you, feel free to look at the photo below.

Next, thread 15 beads and the curve chain. Now thread the other hanging chain. 

Place the 7 remaining beads to complete the hoop.

Thread the hoop's post into its support, then bend the tip upwards with flat pliers to lock the post.

Now, place the different decorative elements on the chains with oval rings.

To finish, open the loop under the earring then thread the square pendant and the hoop. Close the ring.

Make the 2nd loop symmetrically...

Find below the measurements of the chains:

There you go! Beautiful creation!