Natural stone beads
 Flexible 0.4mm brass wire
 Chain
 Clasps and rings if needed

To start, cut a brass wire about 20cm long. If you are working with a drilled stone, thread the wire through the hole. Leave about 3cm of wire protruding from the bead.

Then wrap the thread around the stone making 3 turns. Tighten the thread well.

Wrap the thread around the starting thread to lock it, make 2/3 turns then cut the thread flush.

Then, using round-nose pliers, make a loop on the starting thread. Then wrap the thread about 3 times to make a wrapped loop.

Cut the thread flush.

You can make these necklaces with drilled stones or pointed, raw crystals... For a non-drilled stone, you will need to wrap and tighten the thread well to secure the stone.

Now all you have to do is mount your stone on a chain!

And there you go! Beautiful creation!