Miyuki 11/0 rocailles beads
 3mm rings
 Twisted wire chain or other
 Dura-line Miyuki thread
 A toggle clasp and extension chain
 A needle
 A bead mat

To start, cut a chain about 38cm long and cut it in the middle to get 2 identical pieces. This will allow you to start weaving the central flower.

Cut a nylon thread about 30cm long and thread the needle.

Pass the needle through the first piece of chain then thread 3 beads. Pass through the second piece of chain then thread 3 beads. Keep a starting thread of about 3cm to make the knot at the end.

Pass back through the first chain, you will thus form a loop with the beads. Pull the thread tight.

Then thread a yellow bead for the center of the flower. Pierce the needle directly into the chain opposite and position the bead at the center of the others. (see photo 4)

Next, we will pass through all the border beads to reinforce the assembly.

Pass back through the 3 beads (see photo 5) then through the chain (see photo 6).

Continue like this to go all around and return to the starting point, where the starting thread comes out. (see photo 8)

To finish, make a double knot by passing twice through the loop. Make a second knot, tighten well, then cut flush. 

Continue assembling like this for the other flowers... Here we left 3 twisted links between the flowers and made 7 flowers.

To finish, place the clasp and the extension chain at the ends with 3mm rings.

And there you go! Beautiful creation!

Find all the supplies below...