This creation is very easy to make but requires precision to place the flower in its position. Follow our steps below for optimal assembly!

To start, cut a brass wire about 20cm long and form a wrapped loop at the end. Try to make a small and discreet loop; this will serve to lock the bead.

Then thread a 6mm bead and the flower button. Gently fit the bead into the button. To do this, you can spread the petals carefully without breaking them.

Now thread the flower onto the wire and bring all the elements toward the loop at the end of the wire.

Next, thread the brass wire through the pendant ring. Wrap the brass wire twice around the lower part of the pendant ring. 

Tighten the flower well against the pendant; there should be no play.

Now wrap the thread several times between the flower and the pendant, like for a wrapped loop, then cut the thread flush.

To finish, open a 4mm ring and connect the pendant to the earring ring. Properly close the ring using 2 flat pliers.

Proceed the same way for the other earring.

Your jewelry is finished!

Beautiful creation!