Bracelet Wrapping nacre

✨ Mother of Pearl Bead Wrap Bracelet - The chic and easy DIY to adopt! ✨

Looking for a bright, trendy piece of jewellery that's easy to make? Discover our new tutorial for creating a wrap bracelet around beads. A technique accessible to all, for a modern and refined look.

Using the wrapping method, delicately wrap a thread around the beads to form an elegant bracelet that will enhance your wrist. Ideal for beginners and DIY enthusiasts alike, this piece of jewellery will add a fresh touch to your outfits.

Find all the step-by-step explanations below.

You will need :
0.4 mm brass wire, gilded with 24K fine gold a clasp Gilded with 24K fine gold 24K gold-plated extension chain mother-of-pearl beads

Tools to be used :
jewellery clips

Assembly:

To begin, cut a brass wire approximately 20cm long (adjust this length during assembly to avoid losing wire).

Form a loop at one end of the wire, insert the clasp and then wind the wire around the edge of the loop. This will form a coiled loop that secures the clasp.

Thread a bead and then form a loop around the edge of the bead. Don't cut the wire, just wrap it around the pearl. Don't try to wind the wire too precisely, leave an organic side that will give your arrangement more dynamics and relief.

Then wrap the thread around the edge of the first loop for 2 turns to secure the thread. Cut the thread flush.

Take a new thread, form a loop, insert the loop from the previous assembly and then form the wrapped loop.

Insert a new pearl, then form a loop and wrap it around the pearl. Secure the assembly by wrapping the wire around the edge of the loop.

Continue in this way until you reach the length of your wrist.

For the last bead, thread 3cm of extension chain through the last loop.