This creation is very easy to make, for this we will thread the beads on 2 different threads that will cross throughout the bracelet. You will see it is a very simple weaving technique that will position itself all along the assembly.

To start, cut 2 nylon threads about 30cm each, then pass them through a crimp bead then through the ring of the lobster clasp. Pass back through the crimp bead then flatten it at the edge of the clasp. Thread a first bead onto both threads at the same time then cut off the excess threads.

You can now start the weaving.

Now thread the beads onto the outer threads then gather the threads with a central bead as shown in the image below.

Here for a beautiful result we added metal cube beads between the beads that go outward. This also helps the beads position better.

Continue assembling until the bracelet reaches the correct length.

To finish, thread a crimp bead then a 4cm piece of extension chain then pass back through the crimp bead. Pull on the thread to bring the crimp bead to the edge of the chain and right up to the edge of the last threaded bead.

Flatten the bead then cut the thread flush.

Your jewelry is finished!

Beautiful creation!