For this type of bracelet, you have the choice between several assembly techniques. In elastic version and without clasp for ease of assembly and comfort to wear. With a magnetic clasp for easy putting on and taking off. Or in macramé sliding knot version and/or more elaborate with square knots between the beads!

For the elastic version, nothing could be simpler! Thread the beads and then make a first simple knot. For the second knot, pass through the loop 2 times before tightening the knot well. You can add a small drop of glue on the knot to strengthen it.

For the magnetic clasp version, you can use either linhasita wire, or silk or nylon wire. Make a double knot with one end of the wire on the clasp ring. 

Then thread a metal bead and then your natural beads.

Thread a metal bead again and then make a knot on the other ring of the clasp.

Be careful not to tighten the wire too much, the assembly should remain flexible for comfort.

For the macramé version, choose your wire while paying attention to the thickness of the wire in relation to the hole of the beads and the desired finish.

Make a knot on the wire about 15cm from the end to secure the bead threading. 

Thread the beads, here you will put fewer beads than the circumference of your wrist to leave room for the knot.

At the edge of the bead threading, make another knot to secure them. 

Now make a macramé sliding knot. Find the clasp technique here

For the version with knots between the beads, the knots will be identical to those above. Thread the beads onto the wire as before, leaving the beads loose on the wire, then with a new wire of about 50cm make 2 square knots above the first bead (these are the same as for the sliding knot above).

Bring up the second bead under the knot and then wrap the threads around the bead to make 2 knots underneath it.

Continue until the end and then make a sliding knot to close the bracelet.

And there you go! Beautiful creations ;-)