To begin, unwind your silk thread. Then thread the needle through the hole in the clasp and bring it towards the end of the silk thread.

Tighten the knots at the edge of the clasp ring. To secure the knots, make double knots, i.e. pass the thread through the loop twice before tightening the knot. 

Using a thin rod, place a small dab of glue on the knots, then trim off the excess thread.

Now start stringing the beads, alternating a mother-of-pearl bead with a small 2mm bead.

Continue in this way until you reach the desired length, taking into account the extension string that will be added afterwards.

Finally, thread a 3cm piece of extension chain and tie the knots at the edge of the beads.

To make it easier to position the knot, you can insert a needle into the thread just at the edge of the chain. This way, the knot will be perfectly in place. Watch our video below.

Be careful not to over-tighten the pearl strand, as it should remain flexible.

Your jewelry is finished!

Beautiful creation!