Mother-of-pearl beads
 Flexible 0.7mm brass thread
 Closed rings
 A clasp
 3mm rings
 Extension chain

To start, measure your wrist and adjust the size to your measurement. Here we start with a 16cm wrist, plus the extension chain.

Cut the brass threads to 16cm. Here we used 10.

Depending on the desired look, adjust the number of brass threads.

Then insert the beads randomly on the threads, but remember to leave some without.

Form loops at the ends of the threads. Make fine loops but not too small; they must be able to pass freely over the ring.

Open the created loops, then connect them to the closed rings. Make sure your loops are properly closed.

The threads can cross to play on the dynamics and volume of the bracelet, but be careful not to overdo it to avoid adding tension.

Slightly shape the threads to give them the shape of the bracelet.

To finish, connect the clasp and the extension chain to the closed rings with 3mm rings.

Find below the assembly steps.

And there you have it! Beautiful creation!