a faceted chain gilded with 24K fine gold
an 8mm cushion bead in natural stone
beads set in natural stone gilded with 24K fine gold
2 beads in metal gilded with 24K fine gold
a 24K fine gold gilded eye pin
3mm rings gilded with 24K fine gold
an extension chain or a clasp attachment gilded with 24K fine gold
a 24K fine gold gilded lobster clasp
jewelry making pliers

This piece of jewelry is very simple to make; for this, thread in order: a metal bead, 6 mounted beads, the cushion bead, 6 mounted beads, and a metal bead onto an eye pin.

Form a simple loop similar to the one on the pin, making sure to tighten the beads on the pin so the mounted beads cluster together. Try to make the loop as discreet as possible to give an elegant finish to your creation.

Next, measure your wrist and subtract the length of the previous assembly. Divide the measurement by 2. This gives you the length of the 2 chains that will be attached on each side of the bracelet.

Now cut 2 faceted link chains to size.

Attach the chains on each side of the bead pin directly onto the pin's loops. Open them spirally using flat-nose pliers to avoid deforming the rounded loops.

Then close the loops in the opposite direction to secure the chains. Make sure there is no gap in the loops to prevent a chain from slipping out!

To finish, place the clasp and 3cm of extension chain (or the clasp attachment) at the ends of the chains with 3mm rings.

And there you have it! Beautiful work!