To start, cut a piece of brass wire about 20cm long.

Cut 2 pieces of nugget chains of 15.5cm and one piece of 3cm of diamond chain.

Thread the brass wire through the link of a nugget chain. With the end of the wire, wrap it around 2 turns at the edge of the link to create a wrapped loop. Cut the excess wire flush.

Start threading the beads...

Thread an olive bead, 3 natural beads, 1 metal bead, 3 natural beads, 1 metal bead, and again 3 natural beads.

Now thread the pendant and then continue symmetrically with the beads.

Once all the beads are placed, thread the brass wire through the link of the other nugget chain, and make 2 turns at the edge of the link. Cut the wire flush.

This results in a solid and slightly structured assembly.

Shape the wire into a curve so that it perfectly follows the curve of the neck.

Glue the stone into the setting by placing a small dot of glue.

To finish, place the clasp and the diamond chain at the ends of the chains with 3mm rings.

And there you go! Beautiful creations ;-)