This creation is quite simple to make, follow the explanations below to faithfully reproduce this model.

To start, thread the bead onto the brass wire.

Be careful, the hole of the mother-of-pearl beads is very fine and can be a bit difficult to pass through. If the wire gets stuck, do not force it, take a needle and clear the hole. The brass wire is perfectly suited to the hole size.

Form a loop on the top of the bead then insert the earring loop into the loop. Secure the loop by making 2 wraps with the brass wire between the top of the bead and the earring loop ring. Cut the excess brass wire flush.

For a beautiful result, try to make very discreet loops!

Now, repeat this operation for the bottom of the bead, but this time insert the chain link into the loop before making the wire wraps between the bottom of the bead and the chain link. Cut the excess wire flush.

Before finalizing and cutting the chains, make the second earring symmetrically.

Once the 2 earrings are made, place them side by side to adjust the length of the chains.

Since the beads are unique and not the same size, we will adjust with the length of the chains, so your jewelry will be balanced.

Cut the chains to the length of your choice. Here we have chains about 2.5cm long.

To finish, open a 3mm ring and attach the set pendant to the bottom of the chain.

Do the same for the other earring symmetrically.

Your jewelry is finished!

Beautiful creation!