Inérys Necklace

Succumb to the delicacy of this necklace with its faceted cushion bead in Moonstone and a small Spinel pendant. A clean and subtle creationthat will charm you with its simple assembly and very classy look. You can adapt this model with the stones of your choice to harmonize it with your outfits...
For this project you will need:
A 6mm cushion bead A 6mm set pendant 2 metal rondelle beads An eye pin Ball link chain and fine round chain 3mm rings A clasp and an extension chain

Succumb to the delicacy of this necklace with its faceted cushion bead in Moonstone and a small Spinel pendant.

A clean and subtle creationthat will charm you with its simple assembly and very classy look.

You can adapt this model with the stones of your choice to harmonize it with your outfits...

For this project you will need:

A 6mm cushion bead
A 6mm set pendant
2 metal rondelle beads
An eye pin
Ball link chain and fine round chain
3mm rings
A clasp and an extension chain

The assembly:

To start, measure the size of the necklace you want to make. Here we made a 50cm necklace with an additional 3cm extension chain to adjust it more easily. This necklace will fall roughly above the chest, on the sternum, and the set pendant will be placed above the neckline.

Assemble the necklace: Attach the clasp and the extension chain to the ends of the chain with 3mm rings.

Next, thread the beads onto the eye pin then form a pretty loop. Be careful, the loop should not be too small to allow the chain to slide easily through the ring. Open the loop then insert the necklace chain. Close the loop properly.

Cut a fine chain about 1.2cm long (adjust the length to your taste) then open the loop at the bottom of the bead pin and attach the chain.

At the bottom of it, attach the set pendant with a 3mm ring.