This creation is not very complicated; follow the instructions below to successfully assemble it.

To start, cut 2 pieces of chain keeping 6 ball links. Then take the brass thread and form a wrapped loop by placing one of the chains before wrapping the thread. Cut the brass thread cleanly and, if needed, slightly flatten the brass thread to prevent snagging.

Thread the 3 Lapis Lazuli beads onto the brass thread, then form a wrapped loop symmetrically. Be sure to place the other chain before wrapping the brass thread!

Your first row of the bracelet is now assembled!

Now, thread a crimp bead onto the silk thread, pass the needle through the last link of the chain, then pass back through the crimp bead. Bring it towards the last link, then flatten it gently. Make a double knot with the silk threads at the edge of the crimp bead, then cut the excess thread flush.

To secure the knot, you can place a small dab of glue.

Now thread the mother-of-pearl beads, about 22 beads. Pass through the second hole of the Lapis Lazuli beads, then continue threading the mother-of-pearl beads symmetrically.

Now thread a crimp bead, pass through the last link of the chain, then pass back through the crimp bead. Flatten it gently, making sure there isn't too much tension between the beads. Your threading should remain flexible!

Tie a knot between the last mother-of-pearl bead and the crimp bead, then secure with a small dab of glue.

To finish, connect the clasp and the extension chain (about 3cm) with 3mm rings.

Your jewelry is finished!

Beautiful creation!