This jewelry is very simple to make, for this start the assembly of the center of the bracelet with the pebble connectors.

Open 4 4mm rings and insert 3 mounted beads per ring. Close the rings properly.

Open a 5mm ring and insert in order, a mounted bead ring, a pebble connector, a mounted bead ring and the next pebble. Close the ring properly, being careful with the pebbles. Handle them carefully to avoid damaging them.

Do the same to attach the other mounted beads and the third pebble.

Measure your wrist and subtract 3.4cm (value from the previous assembly with the junction rings). Divide the measurement by 2.

Then cut 2 pieces of nugget chain.

Connect the chains on each side of the pebble assembly with 4mm rings.

Finally, cut an extension chain of about 3cm.

At the ends of the nugget chains, connect the clasp and the extension chain with 3mm rings.

Below you will find the flat layout to guide you in assembling the different elements.

And there you go! Beautiful achievement!