To start, attach the 8mm closed rings to the earring supports. To do this, open the ring at the bottom of the earring, then insert the closed ring. Close the ring properly with flat pliers.

Now cut 3 nylon threads about 20cm long.

Attach the 3 threads to the closed ring with crimp beads. To do this, thread a crimp bead onto the first thread, pass the thread through the closed ring, then back through the crimp bead. Bring the crimp bead towards the edge of the ring, then flatten it with flat pliers. Be careful not to tighten the bead too close to the ring; the threadings must be smooth!

Repeat the operation with the other 2 threads.

Now thread the beads of your choice.

Here we made threadings about 6 / 7cm long, the longest with the mother-of-pearl beads. You can make them all the same size or, like us, play with different lengths.

Hide the starting threads inside 3 beads, then cut the excess thread.

To finish, thread a crimp bead onto the first thread, pass through the ring, then again through the crimp bead and the next 3 beads. Pull the thread to form the bead loop and bring the crimp bead towards the ring.

Flatten the crimp bead with flat pliers, making sure to keep the threading smooth.

Repeat this step with the other 2 threads.

Now repeat all the steps to make the other earring symmetrically.

Your jewelry is finished!

Beautiful creation!