4mm mother-of-pearl beads
Mounted mother-of-pearl beads
Cabochons 6x8mm mother-of-pearl
Earring supports for 6x8mm cabochons
3mm and 4mm rings
0.7mm flexible brass thread
UHU glue
Jewelry making pliers

To start, cut a brass thread about 25cm long.

Divide the 4mm mother-of-pearl bead strand in two, to set aside half for the other earring.

At one end of the brass thread, form a small wrapped loop as in the photo below.

Then string 25 beads on the brass thread.

Count 9 beads starting from the wrapped loop then form a loop with the remaining 16 beads to create the knot loop.

Then twist the loop at the thread crossing to lock it.

Now form a ring at the edge of the loop. This will serve as a hook for the earring support.

String 16 beads again on the thread then form the 2nd loop symmetrically.

Twist the loop at the crossing point.

Now, string the remaining 9 beads and bring them up to the edge of the loop.

To lock the beads, form a small wrapped loop as at the start of the assembly.

You thus obtain a beautiful knot pendant. Shape it nicely and bring it to life by creating curves and rounding the bead loops.

Next, open a 4mm ring and insert 5 small mounted beads, attach the ring to one of the created loops, then close it properly.

Do the same for the other earring.

Finally, glue the cabochons into the earring supports.

Then connect the earring supports with a 3mm ring at the top of the knot pendant.

Do the same for the other earring.

And there you go! Beautiful creation!