To start, cut 2 pieces of 1mm thread about 30cm each and 2 Linhasita threads about 50/60cm.

If you take a pendant with the ring perpendicular (like for the talisman connector) you will not need to place rings. For connectors with holes, place 4mm rings.

Next, thread a 1mm thread and a Linhasita thread through the ring, fold the 1mm thread in half and bring it to the center to become the warp thread. The Linhasita thread will allow you to make knots on the warp thread.

Make the knots as explained in the video, with and without beads.

To finish, place the bracelet in its final position then make a sliding knot with a new thread.

Tie knots at the ends of the warp threads then cut off the excess.

Beautiful creations ;-)