To start, mount the cushion beads on eye pins and form discreet and symmetrical loops.

Then attach the beads to the Earring supports by opening the connecting ring located at the bottom of the earring support. Close it properly.

Now, using 2 flat pliers, open a 5mm ring and insert the enameled mother-of-pearl pendant, the square pendant, and the ring located at the bottom of the bead. Close the ring properly again with the 2 flat pliers.

Do the same with the other earring.

Lightning earrings:

To start, cut 6 pieces of chains of different lengths. Here we made the earrings asymmetrical, one is longer than the other to give contrast to the worn jewelry.

We give you the lengths made but you can perfectly adapt them to your taste.

For one earring, a 2cm chain, a 3cm chain, and a 4cm chain

For the other, a 1cm chain, a 1.5cm chain, and a 2cm chain

Now, attach the spikes to the bottom of the chains with the small oval rings.

To finish, open a 4mm ring and insert the 3 chains, then attach the ring to the earring loop. Do the same for the remaining 3 chains.

Beautiful creation!