6mm Heishi beads
 metal and mother-of-pearl rondelle beads
 a natural bead
 a clasp
 silk thread
 crimp beads

Measurement:

To start, thread the set located at the center of the bracelet (mother-of-pearl spacers, gold spacers, and the natural stone) then measure this threading. You can now undo it and keep it for the next step of the assembly.

Measure your wrist then subtract the value of the previous beads. Also subtract the value of the clasp then add 1cm for ease.

You thus obtain the length of the heishi beads. Now divide this measurement by 2.

Assembly:

Thread a few heishi beads then the crimp bead. Pass through the clasp then back through the crimp bead and the heishi beads.

Bring your beads to the end of the thread then crush the crimp bead. Cut the excess thread flush.

Then thread the remaining Heishi beads. (the last measurement obtained)

Continue threading with the central beads, metal spacers, mother-of-pearl, and the natural bead.

Now thread the remaining Heishi beads to create symmetry.

To finish, thread the crimp bead and the clasp. Pass back through the crimp bead then through a few heishi beads.

Pull on the thread, your bracelet will then position itself in its final shape. Be careful, make sure to close the bracelet to finalize the assembly.

Keep flexibility in the beads then crush the crimp bead.

Cut the excess thread flush.

Tip: Before finalizing the bracelet, always place it in its final shape, clasp closed. This way, you won't risk tightening the beads too much and ending up with a bracelet that is too stiff. Your threading should remain flexible! 

And there you go! Beautiful creation!