|
It's THE essential piece of jewelry at the moment that will make all the difference! Bracelets to be matched with the beads and pendants of your choice...
|
||||
|---|---|---|---|---|
| For this realization you need: | ||||
|
|
||||
| Step 1: | ||||
|
|
For this tutorial, you can use different wires. Wired thread, elastic thread, silk thread, nylon thread, polyester thread... and even brass wire if you want a rigid bangle effect. To start, cut a nylon wire of about 40cm. If you are using a thin wire, pass it through a needle to facilitate threading. Thread 3 beads and then a crimp bead, pass through the clasp ring, then back through the crimp bead and the 3 beads. Pull on the wire to position the beads right at the edge of the clasp. Adjust the wire so that the end reaches the edge of the last bead, then flatten the crimp bead with flat pliers. Continue threading the beads as you wish... If you are placing pendants, first mount them on 3mm rings that you will thread between 2 beads. Once you have the right length of beads, thread another crimp bead and then pass through the link of the chain. Pass through the crimp bead and then through 3 beads. Pull on the wire, naturally your assembly will tighten. Be careful, your row of beads should remain flexible but not loose. You should not see the beads moving on the wire.
Next, flatten the crimp bead and then cut the excess wire flush with the beads. If you want an additional pendant on the clasp, mount the pendant on a 5mm ring. You can then change the pendant as you wish! To finish, measure the bracelet and your wrist, then cut the excess chain. And there you go! Beautiful creation! The tip: Play with different beads and pendants to create various versions of this bracelet and thus harmonize them with all your outfits! |
|||
To be reserved alone or with friends!
Join Perles Corner to discover our new products, exclusive tutorials, and many other surprises... and receive your voucher by email!
Of the chain
