Some chain
 A clasp
 Beads of your choice
 Pendants
 3mm and 5mm rings
 Threads
 Crimp beads

For this tutorial you can use different threads. Wired thread, elastic thread, silk thread, nylon thread, polyester thread... and even brass thread if you want a rigid bangle effect.

To start, cut a nylon thread about 40cm. If you use a fine thread, pass it through a needle to facilitate threading.

Thread 3 beads then a crimp bead, pass through the clasp ring then go back through the crimp bead and the 3 beads. Pull on the thread to position the beads right at the edge of the clasp. Adjust the thread so that the end reaches the edge of the last bead then flatten the crimp bead with flat pliers.

Continue threading the beads as you wish...

If you place pendants, beforehand, mount them on 3mm rings that you will thread between 2 beads.

Once the right length of beads is reached, thread another crimp bead then pass through the chain link.

Go back through the crimp bead then through 3 beads. Pull on the thread, naturally your assembly will tighten.

Be careful, your row of beads must remain flexible but not loose. You should not see the beads move on the thread.

Next, flatten the crimp bead then cut the excess thread flush with the beads.

If you want to have an extra pendant on the clasp, mount the pendant on a 5mm ring. This way you can change the pendant as you wish!

To finish, measure the bracelet and your wrist then cut the excess chain.

And there you go! Beautiful creation! 

The tip: Play with different beads and pendants to create different versions of this bracelet and thus harmonize them with all your outfits!