Miyuki delica 11/0 beads
 2 chevron connectors
 nugget chain
 lobster clasp
 extension chain
 3mm rings
 Miyuki thread and a beading needle

To start, make the central weaving in Brick Stitch.

You can find the technique here: Brick Stitch Weaving

Here is the list of references used on the model: DB0607 - DB0415 - DB2131 - DB2122

Connect the weaving to the connectors:

To do this, start a new thread on the back then come out in the right bead (the tip).

Then go through the connector hole then again through the bead.

Go back through the connector hole then again through the bead.

For more strength, you can repeat the step by going back through the hole then through the bead.

Go back into the beads to come out at the tip on the other side.

Proceed the same way to connect the other connector.

Measure your wrist and the central part (weaving-connectors) then cut 2 pieces of chain.

Connect them to the connectors with 3mm rings.

To finish, attach the lobster clasp to the chain with a 3mm ring.

On the other side, cut a piece of extension chain then connect them with a 3mm ring.

And there you go! Beautiful creation!