a bangle bracelet base
 a 4mm natural stone cabochon
 Linhasita thread 0.5mm
 Jewelry glue

Make the first knot:

To start, cut a Linhasita thread of about 50cm. Fold it in half and pass the loop under the bracelet, first to the left.

Then pass the cord located at the bottom over the top cord to lock it.

Then pass the cord that was on top over the bracelet and insert it into the loop.

Pull on the 2 threads at the same time to properly tighten the knot and keep about the same length on each side.

Make the second knot:

Pass the right cord under the bracelet to create a loop on the right.

Then pass the cord located at the bottom over the top cord.

Then pass the cord that was on top over the bracelet to enter the loop.

Pull on the 2 threads to tighten the knot.

Be careful to have regular knots along the entire length. Do not tighten the knots too much!

Make about 22 knots, alternating loops each time. Right then left then right...

Then tighten the last knot well and cut the remaining threads to about 2mm.

With a thread burner or a lighter, gently burn the threads so they melt and stick to the last knot. Press with your finger to glue the knot.

Do the same symmetrically on the other side of the bracelet...

To finish, place a little glue on the back of the cabochon.

With flat pliers, position the cabochon on the round plate of the bracelet.

Let dry properly before handling the bracelet.

And Voilà! Beautiful creations!