This creation is quite simple to make, you can adjust the number of natural stone beads to your taste. Follow the instructions below to faithfully reproduce this model.

To start, cut a flexible brass wire about 15cm long. Do not take a wire that is too short to be comfortable during assembly. 

At one end of the thread, form a loop then string the pendant into the loop. Be careful to look closely at the bracelet visuals to place the pendants in the correct orientation.

Then wrap the thread around 2 turns at the base of the created loop. Cut the excess thread flush. For a delicate and neat result, form a fairly fine and discreet loop.

Start stringing the beads. String a metal rondelle bead, a 4mm tourmaline, a metal bead, a tourmaline, and again a metal bead. Then string the Venus hair Quartz bead before continuing symmetrically.

Attach the assembly to the other Ginkgo leaf pendant. Form a small discreet loop using round-nose pliers then string the pendant, paying attention to the orientation (symmetry and front face of the bracelet).

Now, calculate the length of the bead/pendant stringing.

Measure your wrist then subtract the length of the stringing from your measurement. Divide the result by 2. This gives you the length of the 2 chains to cut. Here we do not add ease because the clasp and attachment will add some weight to the bracelet. If you want a bracelet that fits snugly on the wrist, adjust the measurements slightly. 

Then, once your 2 chains are adjusted, connect them to the bead assembly with 3mm rings. Attach the chains to the rings located on the back of the pendants.

To finish, open a 3mm ring and connect the clasp to the end of a chain. Do the same for the extension chain with the other chain.

Your jewelry is finished!

Beautiful creation!