2mm faceted Malachite beads
 An oval connector pendant
 Nugget chain
A 10mm lobster clasp
Extension chain
0.4mm brass wire
 3mm rings

To start, measure your wrist size. Then subtract 4cm corresponding to the size of the pendant plus 1cm. Divide the measurement by 2, this gives you the length of the 2 chains to cut.

The value of the clasp and connecting rings will add the ease value of the bracelet.

Cut an extension chain about 3cm long. This will allow you to more easily adjust the bracelet to your wrist.

Start the assembly:

To start, cut a piece of flexible brass wire about 6cm long. 

Thread the wire through the connector hole then wrap the wire around the edge of the hole 2 turns. Cut the excess wire and if needed flatten it with flat pliers.

Now thread 12 Malachite beads... Adjust the number to the size of the slot.

Then thread the wire through the connector hole and wrap it 2 turns between the bead and the edge of the slot.

Cut the excess thread flush.

Now you can slightly bend the pendant to give it a curved shape that will follow your wrist.

To finish, connect the chains on each side of the pendant with 3mm rings.

At the ends, place the clasp and the extension chain with 3mm rings.

And there you go! Beautiful creation!