This creation is not very complicated to make, just follow the instructions below to faithfully reproduce this model. Our video below shows you the essential steps of assembly. Feel free to adapt this model with the beads of your choice! 

Here we used Zirconium Oxide beads for their shine and their appearance close to the transparency and color of snowflakes. 

To start, cut a flexible brass wire of about 60cm. Be careful not to take a wire that is too short to avoid joints.

Wrap the brass wire around the closed ring and neatly cut the excess wire.

Now thread 3 beads onto the wire and then wrap the wire around the ring, forming a small curve with the beads. Tighten the wire well to prevent the beads from moving.

Continue with the same method to place all the beads. With this size of ring, you will place a total of 24 beads, which means 8 modules of 3 beads that will complete the full circle of the ring.

Take the fancy faceted link chain, here 20cm, fold it in half to visualize the central link. Place the central link on the brass wire and then wrap the wire between 2 beads to secure the chain to the ring. Wrap the wire between the bottom of the link and the ring to finish the attachment. Cut the excess wire flush.

Now cut the simple link chain into 2 pieces of 15cm, or longer depending on the desired length of the necklace. Connect the simple link chains to the ends of the fancy chain with jump rings.

At the ends, place the clasp and the extension chain (about 4cm) with jump rings.

And there you go! Your creation is complete! I hope you enjoyed this tutorial and that it inspires you to create with other beads, in Christmas decoration hanging...

Beautiful creation!