nylon thread for bead weaving
 2mm faceted beads 
 a ring support
 beading needles

This jewelry uses a technique commonly used in Miyuki bead weaving on a support. Here we wanted to upgrade this creation by weaving faceted beads made of natural stones. The facets of the beads catch the light and give beautiful reflections to the ring. 

To start, take a thread of about 1 meter. Allow enough thread because you won't be able to make a splice.

Make a knot on one edge of the ring while keeping about 15cm of thread.

On this support, we will create a gradient of beads to fill the void in the center of the ring. For this, you will need to adjust the number of beads to the available space. 

Start with one bead. Thread it onto the needle, then go around the edge of the ring, go back through the bead, and continue to the opposite edge. Follow our diagram below.

With each pass, pull the thread tightly so that the beads are well positioned. 

Be careful to place the right number of beads; too many on the row can create tension, and too few can cause too much play. Don't hesitate to slightly deform the ring support to adapt. Here we have placed 6 beads in the center, spaced out the most from the ring.

Once all the beads are positioned, make a knot inside the ring by piercing the needle into the last thread at the edge. To secure the assembly, you can place a small dot of glue on the knot.

Thread the needle onto the starting thread and make a knot inside the ring.

Beautiful creation!