58 oval metal beads 24K
 The creoles
 Ball stud earrings
 Fine 24K chain
 4mm cabochons and connector supports
 Glue
 Square pendants and small navettes and diamonds
 Oval rings

To start, cut all the chains following the cutting plan below. (see at the bottom of the tutorial)

Tip: To help you cut the chains symmetrically, lay the chain flat in front of a ruler. Then locate the link to remove, at the measurement level. Next, grab this link with the cutting pliers, lift the chain, naturally the chains will fall down, giving you the cutting mark for the 2nd piece of chain. Cut at the right place.

Thread 7 beads onto the hoop, then the 2 pieces of chain (the one that hangs outside and the one that will curve under the hoop).

To guide you, feel free to look at the photo below.

Then, thread 15 beads and the curve chain. Now thread the other hanging chain. 

Place the 7 remaining beads to finish the hoop.

Thread the stem of the hoop into its support, then bend the end upwards with flat pliers to secure the stem.

Now, place the different decorative elements on the chains with oval rings.

To finish, open the loop under the bo and thread the square pendant and the hoop. Close the ring.

Make the 2nd loop symmetrically...

Find below the measurements of the chains:

And there you go! Beautiful creation!