bohemian beads 6mm, 8mm, and 10mm
 linhasita thread 0.5mm
 closed rings 8mm
 a screw clasp

To start, cut a linhasita thread of about 60cm.

To connect the thread to the clasp, make a series of 3 knots with the end of the thread on a closed 8mm ring. Then cut the excess and burn the small end of the thread to secure the knot.

Thread the beads starting with the 6mm beads, then the 8mm, and the 10mm in the center. Then go back symmetrically to finish threading.

Thread the 8mm ring and then make a series of 3 knots right at the edge of the ring.

Be careful to maintain fluidity between the beads; to do this, before making the knots, place the necklace in a curve. A necklace that is too rigid will not be comfortable to wear!

To finish, place the screw clasp to connect the closed rings.

And there you go! Beautiful creation!