earring supports
 mother-of-pearl beads
 2 24K gold round beads
 0.4mm brass wire or copper wire

To make these earrings you have 2 mounting options. With brass wire or with copper wire, but each assembly will be different. Here are the explanations...

With the brass wire:

To start, cut a piece of wire about 20cm long and then form a loop at one end.

Then string the beads onto the wire.

Once the beads are strung, cut the wire leaving about 8mm and then form a loop at the end of the wire.

Open the ring located on the back of the earring and then insert the 2 loops. Close the ring. The beads will naturally position themselves in a drop shape.

With the copper wire:

Cut a piece of wire and then wrap the end of the wire directly around the ring of the earring. (about 3 passes through the ring) Cut the excess for a clean finish.

String the beads and then wrap the end of the wire around the ring to shape the beads into a drop. Cut the excess wire.

And there you go! Beautiful creation!

In both versions, be careful when handling the wires, do not crush the wires too much with the pliers at the risk of breaking them.