Amethyst Graphic Loops – Suspended Elegance

Succumb to the finesse of these graphic earrings: a lovely dangling gold chain supports a teardrop amethyst pearl, bringing a natural and feminine shine.

Easy to wear, they instantly enhance all your outfits with a bright and contemporary touch. To be paired with the pearls of your choice!

Find all the step-by-step explanations below.

For this creation you will need:
Gold-plated ball stud earrings 24K Gold-plated fancy link chain 24K 2 drop gemstone beads 0.4mm Gold-plated brass wire 24K

The tools to use:
jewelry creation pliers

The assembly:

To start, cut a piece of brass wire about 10cm long.

Cut 2 pieces of chain about 5cm long.

String the drop bead and then cross the wires at the top of the drop.

Twist one of the 2 wires around the other for 2 turns, then cut the excess flush. If necessary, flatten the cut with flat pliers.

Now take round-nose pliers and form a small loop with the remaining wire.

Insert the chain before finalizing the assembly.

Secure the loop with flat pliers and then wrap the wire between the tip of the drop and the loop for several turns. Make as many turns as you like; this dresses up the top of the bead and provides a nice finish!

Cut the excess wire flush.

To finish, gently open the ring at the bottom of the earring in a spiral towards the side. Insert the chain and then close the ring. Be careful to only open the ring just enough to pass the link, as opening it too much may weaken the attachment or even break the ring.

Start all the steps again to make the other earring.

And there you go! Your creation is complete.

Beautiful creation!