To start, select your beads. Play with colors and shapes to give depth to your creation.

Mount the 6 drop beads on ball head pins and form pretty loops of normal sizes, neither too small nor too large. Your loop should correspond approximately to the size of a 4mm ring.

Make 2 assemblies of 3 faceted oval beads on eye pins.

Make 8 assemblies of 4 round beads 4mm on eye pins.

Connect the pins together by following the instructions below.

The pin with the oval beads serves as a connection between the different bead pins.

Open a loop of the pin (oval beads), insert a round bead assembly, a drop bead pin, and a round bead pin. Close the loop.

Repeat this step on the other side.

Connect the round bead pins, at the bottom of the assembly, to the ring of the central drop bead.

To connect the round bead pins at the top of the assembly, use a 4mm ring that will also be connected to the ring of the earring support.

This ring will serve as a connection and will allow the pins to fall perfectly in the right direction. Your assembly will thus be positioned facing forward once worn.

Start all the steps again to make the other earring.

And there you go! Your creation is complete.

Beautiful creation!