This creation is very easy to make, but will require precision to place the flower in its position. Follow our steps below for optimal assembly!

To start, cut a piece of brass wire about 20cm long and form a wrapped loop at the end. Try to make a small and discreet loop, this will serve to block the bead.

Then thread a 6mm bead and the flower button. Gently fit the bead into the button. For this, you can spread the petals while being careful not to break them.

Now slide the flower onto the wire and bring all the elements towards the loop at the end of the wire.

Then thread the brass wire through the ring of the pendant. Wrap the brass wire 2 times around the lower part of the pendant ring. 

Tighten the flower well against the pendant, there should be no play.

Now wrap the wire several times between the flower and the pendant, as for a wrapped loop, then cut the wire flush.

To finish, open a 4mm ring and connect the pendant to the ring of the earring. Close the ring properly using 2 flat pliers.

Proceed in the same way for the other earring.

Your jewelry is finished!

Beautiful creation!