This creation is quite simple to make, follow the instructions below to faithfully reproduce this model.

To start, thread the bead onto the brass wire.

Be careful, the hole of the mother-of-pearl beads is very fine and can be a bit difficult to pass through. If the wire gets stuck, do not force it, take a needle and clear the hole. The brass wire is perfectly suited to the size of the hole.

Form a loop at the top of the bead and then insert the earring into the loop. Secure the loop by making 2 turns with the brass wire between the top of the bead and the earring ring. Cut the excess brass wire flush.

For a nice finish, try to make very discreet loops!

Now, repeat this operation for the bottom of the bead, but this time insert the chain link into the loop before making the wire turns between the bottom of the bead and the chain link. Cut the excess wire flush.

Before finalizing and cutting the chains, make the second earring in symmetry.

Once the 2 earrings are made, position them side by side to adjust the length of the chains.

As the beads are unique and not the same size, we will adjust with the length of the chains, so your jewelry will be balanced.

Cut the chains to the length of your choice. Here we have chains of about 2.5cm.

To finish, open a 3mm ring and connect the set pendant to the bottom of the chain.

Do the same for the other earring in symmetry.

Your jewelry is finished!

Beautiful creation!