To start, mount the cushion beads on eye pins and form discreet and symmetrical loops.

Then connect the beads to the earring supports by opening the junction ring located at the bottom of the support. Close it properly.

Now with the help of 2 flat pliers, open a 5mm ring and insert the enamelled mother-of-pearl pendant, the square pendant and the ring located at the bottom of the pearl. Close the ring properly using the 2 flat pliers.

Do the same with the other earring.

Earring flashes:

To start, cut 6 pieces of chains of different lengths. Here we made the loops asymmetrically, one is longer than the other to give contrast to the worn jewelry.

We give you the lengths made but you can perfectly adapt them to your taste.

For one loop, a chain of 2cm, one of 3cm and one of 4cm

For the other one, a chain of 1cm, one of 1.5cm and one of 2cm

Now, connect the spikes to the bottom of the chains with the small oval rings.

To finish, open a 4mm ring and insert the 3 chains, then connect the ring to the earring loop. Do the same for the remaining 3 chains.

Beautiful creation!