|
These earrings are made up of a set of rings of different sizes and topped with beautiful flat mother-of-pearl. The fluid lines of this creation bring a lot of softness and delicacy. You can customize them with the stone of your choice...
|
||||
|---|---|---|---|---|
| For this project you will need: | ||||
|
|
||||
| Step 1: | ||||
|
|
To start, glue your cabochons into the supports, making sure not to use too much glue. Tip: Place a little glue in the center of the support. A small dot of glue will be enough, the placement of the cabochon will spread the glue. Position the cabochon and then press it to secure it well. Wait a few minutes to avoid weakening the bond. Next, open a 5mm ring and insert in order, the largest ring, the medium one, and the smallest. Finish with the BO support and then properly close the ring. And there you go! Beautiful creation! |
|||
To be reserved alone or with friends!
Join Perles Corner to discover our new products, exclusive tutorials, and many other surprises... and receive your voucher by email!
Closed rings
