Rounded earrings
 Miyuki Delica 11/0 beads
 Brass wire
 A circle connector
 Crystal Quartz beads
 4mm rings

To start, open a 4mm ring and thread 3 Miyuki beads. Place the ring around the pendant and then close it properly using 2 flat pliers.

Repeat this step to place 6 rings per pendant, ensuring they are positioned symmetrically relative to the pendant rings. This will give you small clusters of beads.

Then cut a brass wire about 15cm long and bend it in half with round-nose pliers to form a small loop. Thread a Miyuki bead onto the wire and then twist the wires to secure the bead in the loop.

Thread the Quartz bead onto the wires.

With one of the wires, form a loop at the top of the bead, thread the pendant ring through the loop, then wrap the wire around the loop for 2 turns. This closes the loop and secures it. Cut the wire flush.

With the remaining wire, fold it towards the loop located at the bottom of the Quartz bead, wrap it once between the loop and the bead, then bring it up crossing the wire to form an X on the bead.

To finish, wrap the wire between the top of the bead and the loop. Cut the wire flush.

Then open the ring of the BO and connect the pendant.

And there you go! Beautiful creation!