Faceted Malachite beads 2mm
 Nugget chain
A buoy clasp
Extension chain
Brass wire 0.4mm
 3mm rings

To start, measure the size of your neck leaving a little room. This necklace should fall at the level of the collarbones. Here we made a choker of 40cm. (Total size, clasp without the extension chain)

The extension chain will allow you to adjust the necklace more easily and adapt it to your different outfits. Be careful not to forget that the clasp must be included in your measurement.

Cut an extension chain of about 5cm. This will allow you to adjust the necklace more easily to your outfits depending on the necklines.

Start the assembly:

To start, cut 10 pieces of nugget chain while keeping 3 nuggets.

Take your brass wire and form a loop using the round-nose pliers about 2cm from the end.

Thread a nugget link into the created loop and then wrap the wire around the edge of the loop for 2 turns. This secures the loop and the chain and stabilizes the assembly.

Then thread 8 Malachite beads...

Still using the round-nose pliers, form a small loop 1mm from the last bead and then thread a new piece of nugget chain. To secure the loop, wrap the wire between the loop and the last bead for 2 turns.

Cut the excess wire flush.

If your wire sticks out a bit, gently flatten it with flat pliers. This will prevent you from getting scratched and snagging your clothes.

Continue like this until you have made 9 bead assemblies connected to the 10 pieces of nugget chain.

To finish, attach the buoy clasp on one side by opening its ring. On the other side of the necklace, attach the extension chain with a 3mm ring.

And there you go! Beautiful creation!