Step 1:

To start, cut a piece of brass wire about 20cm long.

Then cut 2 pieces of chain about 15cm long. Here we made a choker necklace of 40cm. If you want a looser drape, feel free to lengthen the chains.

At one end of the wire, form a loop and then insert the link of the chain. Then wrap the end of the wire at the bottom of the loop for 2 turns to create a wrapped loop.

This allows for a clean and very sturdy assembly. Cut the excess wire flush.

Start threading the beads by alternating the donuts, metal beads, and pendants. Follow the order of the beads in the photo below.

The size of the threading will be ideal on the neck, neither too long nor too short.

In the center, place the enamel pendant and then continue symmetrically... 

Step 2:

Once your threading is complete, form a loop at the edge of the last bead and then insert the other piece of chain.

Form a wrapped loop as before. Be sure to make the loops discreet enough for a fine assembly.

For a nice drape, shape the bead threading to give it a curve that will follow your neck.

Then cut a piece of extension chain about 3cm long.

At the ends of the chains, place the clasp with a ring on one side and the extension chain on the other.