To start, mount the faceted Moonstone Feldspar beads onto ball head pins. Form nice discreet loops at the edge of the beads.

Now start threading the beads onto the brass wire. Cut a brass wire of about 25cm.

We will create the threading symmetrically. Thread the previous assembly, bead on pin, onto the brass wire.

On each side, place metal teardrop beads, 6mm bohemian beads, and golden rondelles. Place 6mm beads again, then faceted metal beads.

Then thread 4mm bohemian beads, striped metal beads, 4mm beads, and again striped golden metal beads. Finish with 3 bohemian 3mm beads on each side. 

Look at the photo below to follow the bead assembly correctly.

Gather the brass wires together in a rondelle bead and a faceted golden metal bead. Tighten the wire well; this will naturally form a bead assembly in a drop shape. If necessary, reshape the drop to make it harmonious, well-rounded, and not too elongated.

With one of the 2 brass wires, form a loop. To do this, bend the wire at a right angle tightly against the edge of the metal bead, cut the excess to keep about 1cm, and form a simple loop using round-nose pliers.

Thread the earring support into the created loop.

Then, hold the pearl loop assembly in one hand and wrap the second brass wire around once between the golden bead and the created loop. Cut the excess wire flush on the back of the earring. Flatten the cut of the brass wire with flat pliers.

To finish, glue the cabochon into the setting, making sure not to use too much glue.

Repeat the steps for the other earring...

Your jewel is finished!

Beautiful creation!