This creation is very easy to make, you can adapt the number of natural stone beads to your taste. Play with close shades or play with contrasts and/or benefits!

To start, cut a flexible brass wire about 10/15cm long. Length to adjust depending on the number of beads chosen. For a nice look on the wrist, do not exceed 4cm, the length of the chains would become disproportionate. 

At one end of the wire, form a loop then place the chain, then wrap the wire 2 times at the base of the loop. Cut the excess wire flush. For a delicate and neat result, form a fairly fine loop.

We will cut the chain afterwards, once the bead assembly is done, to know the exact size of the bracelet.

Start threading the beads. Play with alternating metal beads to add rhythm. Place the 6mm cushion bead in the center then continue symmetrically.

Now, calculate the threading length of beads.

Measure your wrist then subtract the threading length from your measurement. Divide the result by 2. This gives you the length of the 2 chains to cut. Here we do not add ease because the clasp and attachment will add some weight to the bracelet. If you want a bracelet snug on the wrist, adjust the measurements slightly. 

Then, once your 2 chains are adjusted, form a loop 1mm from the last bead. Thread the 2nd chain through the loop then wrap the brass wire around the edge of the loop 2 times and cut the wire flush.

To finish, open a 3mm ring and connect the clasp to the end of a chain. Do the same for the clasp attachment with the other chain.

Your jewelry is finished!

Beautiful creation!